Source apportionment in SMOKE consists of grouping sources by characteristics (i.e. FIPS code, SCC, and point source information) and then tagging the emissions from those groupings for further analysis in the air quality model. The SMOKE programs Movesmrg and Smkmerge can optionally output the emissions in special files used for later source apportionment processing.
The following steps outline the process for creating the source apportionment output files:
Define source groups using the SOURCE_GROUPS
file
The format for the SOURCE_GROUPS
file is described in Section 8.10.12, “SOURCE_GROUPS
: Source apportionment groups”. When assigning sources to groups, SMOKE will match each source to the most specific line in the SOURCE_GROUPS
file. The hierarchy of assignment priority is listed below.
Country/state/county code, SCC, plant ID, point ID [point sources only]
Country/state/county code, SCC, plant ID [point sources only]
Country/state/county code, plant ID, point ID [point sources only]
Country/state/county code, plant ID [point sources only]
Country/state/county code, SCC [non-biogenic sources only]
Country/state code, SCC [non-biogenic sources only]
SCC [non-biogenic sources only]
Country/state/county code
Country/state code
Default group (country/state/county code = 0, SCC = 0)
Define locations for the output files SRCGROUPS_OUT
(source group information), SGINLNTS_L
(emissions data), and SRCGRP_REPORT
(source group report file)
For point source processing, use in-line plume rise calculation
Review Section 4.4.18, “In-line Plume Rise Calculation in CMAQ model (as of version 4.7)” for instructions on configuring Elevpoint and Laypoint for in-line emissions processing.
After completing other SMOKE processing, run Movesmrg (on-road mobile emissions using MOVES lookup tables) or Smkmerge with SMK_SRCGROUP_OUTPUT_YN
set to Y
When processing emissions using source apportionment, you can only run Smkmerge for a single source category (i.e. A, B, M, or P). For point source processing, Smkmerge cannot merge layers (MRG_LAYERS_YN
must be N) and in-line emissions must be output (SMK_ELEV_METHOD
must be 2). Movesmrg and Smkmerge will create both the source apportionment data files and the model-ready output files in a single run. For biogenics, if
you are running Smkmerge for reporting purposes (i.e. to create state and county totals), make sure to set the units correctly for the source apportionment
output data, typically the same as the model-ready output units.
Review source grouping assignments
After running Movesmrg or Smkmerge, the SRCGRP_REPORT
file will list each source in the inventory and the group it was assigned to. You can review this report to verify that the
sources were grouped as desired.